Added set of Error counters to 150 in each iteration.

CAN FD Standard sets the counter to value between
119 and 127 ich frame is successfully transmitted
in error passive!!!

test/feature/suspend_transmission_feature_tb.vhd

@@ -46,14 +46,15 @@
 --      2. Read out error state of both nodes. Check that Node 1 is error 
 --         passive, and Node 2 is error active.
 --      Loop (Forever):
---          3. Insert frame to two TXT Buffers of Node 1. Insert frame to Node 2.
---          4. Wait until Node 1 starts transmission.
---          5. Insert frame to Node 2.
---          6. Wait until frame is transmitted by Node 1 (end of EOF).
---          7. Wait for 3 Bit times, to compensate for Intermission field!
---          8. Wait for N Bit times (suspend field).
---          9. Give command to Node 2 to start Transmission.
---         10. Check that Node 1 did become receiver, not transmitter although
+--          3. Set Error counter to 150 to force erro passive again!
+--          4. Insert frame to two TXT Buffers of Node 1. Insert frame to Node 2.
+--          5. Wait until Node 1 starts transmission.
+--          6. Insert frame to Node 2.
+--          7. Wait until frame is transmitted by Node 1 (end of EOF).
+--          8. Wait for 3 Bit times, to compensate for Intermission field!
+--          9. Wait for N Bit times (suspend field).
+--         10. Give command to Node 2 to start Transmission.
+--         11. Check that Node 1 did become receiver, not transmitter although
 --             it has frame for transmission available. It can become transmi-
 --             tter only if we waited more than 7 bits! Break out of loop in
 --             this case and check that N=8!
@@ -154,6 +155,12 @@ package body suspend_transmission_feature is
 
         while (true) loop
 
+            --------------------------------------------------------------------
+            -- Reset Error counters to 150 again. 
+            --------------------------------------------------------------------
+            error_ctrs.rx_counter := 150;
+            set_error_counters(error_ctrs, ID_1, mem_bus(1));        
+        
             --------------------------------------------------------------------
             -- Send two frames from Node 1. First will start transmission.
             -- Then Add the same frame to Node 2.